Non-standard sheet EPS production

 
Manufacturing nonstandard foam sheet
At maximum input block sizes 4000h1250h1000mm the possibility of manufacturing nonstandard plates is available.
For example, for a plate of sandwich panels, often using 2500h1250h50mm size or thickness of 100 mm. (Sheet thickness of 20 mm to 1000 mm)
For convenience mounting with insulation of large areas of the roof and floor, basement and ground floors used plate size of 1000h1000h100 2000h1000h100mm. At the same time warming significantly reduced number of joints between the plates, and thus much less cold bridges.
 
The building is losing up to 20% of heat through the roof. Moreover, the roof is a strategic place in terms of energy efficiency of the building, as it is up under the roof, the warm air - all over the building understands. There, he comes into contact with a cold blade overlap, resulting in condensation occurs. Therefore special attention when the roof insulation should be given not only to the conservation of heat and steam control.
 
Foam insulation of the roof - one of the most popular and widely used solutions for today. It is especially well suited for a pitched roof to the rafters. As the distance between the rafters, you can put a nonstandard sheet foam. The rafters themselves are excellent frame for insulation. If we are dealing with overlapping technology insulation is:
 
1. Before installation of insulation is necessary to organize waterproofing. To do this, the entire surface of the roof waterproofing membrane is stretched. In this case, the film should be a special vapor permeability, just to let off steam, but do not admit.
 
2. After doing waterproofing is necessary to mount the heater. Foam roof insulation of the mounting plates of polystyrene on the frame formed from the rafters. Installation is performed using special plugs and the gap between the panels blow out the mounting foam.
 
3. Top of a layer of insulation is necessary to make additional protection against moisture penetration. Therefore need to give another layer of waterproofing film, and only then you can write to the rafters and continue drywall finishing.
Expanded polystyrene - a great choice, since the very surface of the material is resistant to the development of micro-organisms (they do not survive on a polystyrene basis), and the quality of insulation is not reduced by soaking